文章摘要
张银花,刘绪平,易巧,李景莲.药包材双向拉伸聚丙烯真空镀铝流延聚丙烯复合膜近红外光谱快速鉴别方法研究[J].中国药事,2017,(8):925-932
药包材双向拉伸聚丙烯真空镀铝流延聚丙烯复合膜近红外光谱快速鉴别方法研究
Study on Rapid Identification Method of Near Infrared Spectrum of Twoway Stretch Polypropylene Vacuum Aluminum Plating Cast Polypropylene Composite Membrane
投稿时间:2016-06-29  
DOI:10.16153/j.1002-7777.2017.08.016
中文关键词: 药品包装材料  双向拉伸聚丙烯  真空镀铝流延聚丙烯  近红外  快速鉴别
英文关键词: medicine packing material  two-way stretch polypropylene  vacuum aluminum plating cast polypropylene composite membrane  near infrared  rapid identification
基金项目:江西省食品药品监督管理局科技计划:基于近红外光谱和拉曼光谱技术的化学药品基本药物目录品种快速检测技术研究(编号2015YP06)
作者单位E-mail
张银花 江西省药品检验检测研究院, 江西省药品与医疗器械质量工程技术研究中心, 南昌 330029  
刘绪平 江西省药品检验检测研究院, 江西省药品与医疗器械质量工程技术研究中心, 南昌 330029 shanyezao@yeah.net 
易巧 江西省药品检验检测研究院, 江西省药品与医疗器械质量工程技术研究中心, 南昌 330029  
李景莲 南京军区南昌药品器材供应站, 南昌 330029  
摘要点击次数: 830
全文下载次数: 430
中文摘要:
      目的:建立双向拉伸聚丙烯/真空镀铝流延聚丙烯复合膜的近红外光谱快速鉴别方法。方法:采用近红外光谱仪,对26批复合膜的正、反面光谱分别建立聚类分析、一致性检验及相关系数模型。结果:通过聚类分析与一致性检验,参考样品与验证样品得到了很好的区分;通过相关系数分析,参考样品相关系数均在阈值98%以上,不同材质的验证样品相关系数均低于阈值98%。结论:通过采用其他4种不同材质样品,包括双向拉伸聚丙烯/聚酯/聚乙烯复合膜、聚酯/镀铝/聚乙烯复合膜、聚酯/镀铝聚酯/聚乙烯复合膜、非参考样品材质的复合膜样品,对模型的验证结果来看,本方法快速、准确,可用于对双向拉伸聚丙烯/真空镀铝流延聚丙烯材质复合膜的快速筛查。
英文摘要:
      Objective: To establish a rapid identification method of near infrared spectrum of two-way stretch polypropylene/vacuum aluminum plating cast polypropylene composite membrane (thereinafter were named reference samples). Methods: The clusting analysis, consistency test and correlation coefficient model of the positive and reverse spectrums of the 26 batches composite membrane were set up by using the near infrared spectrometer. Results: The reference samples and the verification samples was well sorted by using the clusting analysis and consistency test. The correlation coefficient of reference samples was above 98% of the threshold value by using correlation coefficient analysis. The correlation coefficient of different verification samples was below 98% of the threshold value. Conclusion: This method was rapid, accurate and could be used for rapid screening of the two-way stretch polypropylene/vacuum aluminum plating cast polypropylene composite membranes based on the verification results of the model using four different samples, including two-way stretch polypropylene/Polyester/PE composite membrane, polyester/aluminized/polyethylene composite membrane, polyester/aluminum plated polyester/PE composite membrane, and a composite membrane of non reference sample material (batch number 1116).
查看全文   查看/发表评论  下载PDF阅读器
关闭